ClimateRight CR-2550 Instrukcja Właściciela Pobierz pdf (Strona 285)

7-40

CHAPTER 7

MerCruiser Engine

4. When checking or ﬁ lling the engine crankcase oil ensure that the

vessel is level in the water or on a trailer.

For changing the engine oil & ﬁ lter see the MerCruiser maintenance

schedule and operation manual or contact your Regal dealer.

Note: Above are basic recommendations. Regal is not responsible for the accuracy of

the information since it can change at any time. For more detailed information and

procedures check your engine operators manual or call your closest Regal dealer.

Checking Engine Crankcase Oil

1. Check the engine oil by ﬁ rst allowing the engine to warm up. Stop

the engine and allow about 5 minutes for the oil to drain to the oil pan

to obtain an accurate reading.

2. Remove the dipstick. Wipe it clean and reinstall it into the dipstick

tube. Wait 1 minute to allow any trapped air to vent. ( Install dipstick

with oil indication marks facing the ﬂ ywheel end of the engine. Add

Mercury/Quicksilver Synthetic Blend MerCruiser Engine Oil 25W-40

to bring the level up to the full or OK points on the oil dipstick.

DO NOT OVERFILL.

3. Remove the dipstick and look at the oil level. Level must be between

full or OK range and add. Reinstall dipstick into the tube.

NOTICE

ADDING 1 QUART OF ENGINE OIL WILL RAISE

THE OIL LEVEL FROM THE ADD MARK

TO THE TOP OF THE OK RANGE.