
CHAPTER 6
6-42
Battery Information
The Garmin chart plotter uses a removable lithium-ion rechargable
battery. Replacement batteries can be found at marine supply stores,
authorized Regal dealers or from Garmin on-line.
The battery will generally last from 6-8 hours before recharging becomes
necessary. Normally the battery is charged through the engine battery/
charging system. Before using the battery for the 1st time charge it for
at least 6 hours. Remember this is a back-up battery. Use external power
whenever possible. If device is not to be used for periods longer than
1 week remove the battery pack.
To Remove Battery Pack:
1. The battery is located on the back face of the plotter unit. Lift up
the battery locking ring and turn it counter-clockwise.
2. Tilt the battery pack away from the device and lift it out.
To Insert Battery Pack:
1. On the back of the chart plotter, fi t the bottom of the battery pack
into the device.
2. Tilt the battery pack toward the device until it is tight.
3. Turn the locking ring clockwise to lock the battery pack in place.
To Remove SD Card:
1. Remove the battery.
2. Press the SD card until it clicks softly and releases from card slot.
3. Remove the SD card.
CHAPTER 6
6-42
Battery Information
The Garmin chart plotter uses a removable lithium-ion rechargable
battery. Replacement batteries can be found at marine supply stores,
authorized Regal dealers or from Garmin on-line.
The battery will generally last from 6-8 hours before recharging becomes
necessary. Normally the battery is charged through the engine battery/
charging system. Before using the battery for the 1st time charge it for
at least 6 hours. Remember this is a back-up battery. Use external power
whenever possible. If device is not to be used for periods longer than
1 week remove the battery pack.
To Remove Battery Pack:
1. The battery is located on the back face of the plotter unit. Lift up
the battery locking ring and turn it counter-clockwise.
2. Tilt the battery pack away from the device and lift it out.
To Insert Battery Pack:
1. On the back of the chart plotter, fi t the bottom of the battery pack
into the device.
2. Tilt the battery pack toward the device until it is tight.
3. Turn the locking ring clockwise to lock the battery pack in place.
To Remove SD Card:
1. Remove the battery.
2. Press the SD card until it clicks softly and releases from card slot.
3. Remove the SD card.
Komentarze do niniejszej Instrukcji